Elvis_Presley Posted September 12, 2020 Share Posted September 12, 2020 (edited) My car (2008 outback XT with performance parts and a tune) is pretty new to me. Here's what just happened: Yesterday, I went to replace my cabin filter and discovered none there. The previous owner had routed the wires for the aftermarket (AEM) gauges through there and never put a filter back in. I pushed the wires aside and got it the filter to work. This might not be related but today, I got a blinking cruise control light, a blinking S mode light and a check engine light--and the boost gauge reads really high (not on the dial, but on the center number displayed). It runs just fine though. So with the little daylight, I had left after work, I removed the filter and checked the wiring connections but I still get the same warnings and gauge issue when I turn the car on. I need to get my code reader back from the dude I loaned it to, but do you have any ideas for me? Do the wires for the boost gauge also go to the car's ECM, or whatever you call it on a Subaru? Edited September 12, 2020 by Elvis_Presley Link to comment Share on other sites More sharing options...
Max Capacity Posted September 19, 2020 Share Posted September 19, 2020 Any updates ? You may have wanted to ask this in the 4thGen Forum 305,600miles 5/2012 ej257 short block, 8/2011 installed VF52 turbo, @20.8psi, 280whp, 300ftlbs. (SOLD). CHECK your oil, these cars use it. Engine Build - Click Here Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now