tealdub Posted February 25, 2009 Share Posted February 25, 2009 Will these work on my 09 specB? To elaborate, are they about the same length/size? D4030FE000 Link to comment Share on other sites More sharing options...
fonts Posted February 26, 2009 Share Posted February 26, 2009 I wouldn't think that there would be a whole bunch of difference for exhaust hangers. You should be OK. I assume that you already have your hands on the STi ones. If not keep in mind that Cobb, AVO, and Kartboy also make exhaust hangers. Link to comment Share on other sites More sharing options...
korpsepatrol Posted February 26, 2009 Share Posted February 26, 2009 Also rallitek which are good(used them) polyurethane and cheap. They had them for sale for 3 bucks for December i believe and now they are like 6 bucks. 2008 6mt Legacy Gt Spec B DGM - Not so Stock/Work in progress 2006 5mt Legacy Gt OBP - Sold 2005 5eat Legacy Gt OBP - RIP R.I.P Coxx Link to comment Share on other sites More sharing options...
tealdub Posted February 26, 2009 Author Share Posted February 26, 2009 Thanks...I ordered them from the dealer and installed them already. Big improvement. I was able to get them for around $7 and some change each. FYI: takes two for each muffler and one on the y-pipe. Link to comment Share on other sites More sharing options...
korpsepatrol Posted February 26, 2009 Share Posted February 26, 2009 Thanks...I ordered them from the dealer and installed them already. Big improvement. I was able to get them for around $7 and some change each. FYI: takes two for each muffler and one on the y-pipe. Awesome glad it worked out, so what do you mean by big improvement? I just know mine tucked my exhaust a bit more. 2008 6mt Legacy Gt Spec B DGM - Not so Stock/Work in progress 2006 5mt Legacy Gt OBP - Sold 2005 5eat Legacy Gt OBP - RIP R.I.P Coxx Link to comment Share on other sites More sharing options...
tealdub Posted February 26, 2009 Author Share Posted February 26, 2009 Big improvement quality wise. They will help keep my y-pipe from moving since the fitment is very close to a heat shield back there. Link to comment Share on other sites More sharing options...
snow05gtRI Posted February 26, 2009 Share Posted February 26, 2009 i need to put new exhaust hangers on. mine are sagging and make the pipes hang awkward in the cutouts. whats the process in removing/installing them? i'm gonna search but figured i'd ask as well since you JUST did it. I tried (briefly) to remove one once but it seemed like it could be a pain. Link to comment Share on other sites More sharing options...
tealdub Posted February 26, 2009 Author Share Posted February 26, 2009 Use some silicone spray and spray down the hangers and the rubber hangers. Let it sit for a couple minutes then grab a long flat screwdriver or pry bar and go to town. Pretty simple when done that way. Hope that helps. Link to comment Share on other sites More sharing options...
snow05gtRI Posted February 26, 2009 Share Posted February 26, 2009 it does help. thank you. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.