moral hazard Posted October 14, 2019 Share Posted October 14, 2019 Good to see you're making progress on this! Link to comment Share on other sites More sharing options...
dwmccauley01 Posted October 14, 2019 Author Share Posted October 14, 2019 Good to see you're making progress on this!Yeah man, thanks for the help Sent from my VS501 using Tapatalk Link to comment Share on other sites More sharing options...
dwmccauley01 Posted November 3, 2019 Author Share Posted November 3, 2019 (edited) An update: Installed an AEM wideband and have the learned AF values within 4% so I will move onto open loop very soon after I get closed loop closer to 0%. Fine learning correction table is clean and no feedback under -2.00 has been seen. One thing Im not sure about is by virtual dyno numbers. I know I'm not hurting anything, I just dont know why my torque is so high. I may have set up something wrong so I'll try again sometime soon. My mods are a 73mm shortram intake utilizing the stock snorkle and a catless uppipe. The dyno was taken in 3rd gear and you can see at the end where I let off the gas too soon so I amagine the WHP would be around 185-190. Edited November 4, 2019 by dwmccauley01 Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now