annie1995williams Posted August 28, 2019 Share Posted August 28, 2019 We took off the intake in Hope's to find the oil leak, got everything hooked up and put back now it wont crank and we are getting a run mode system check on the dash. Everything seems to be ground out properly. Any ideas what this could be. Sent from my SM-N950U using Tapatalk Link to comment Share on other sites More sharing options...
Max Capacity Posted August 28, 2019 Share Posted August 28, 2019 First thing is, step back a minute, go back over all the connections, make sure the big gray harness is fully connected, as well as the grounds are all clean and tight. 305,600miles 5/2012 ej257 short block, 8/2011 installed VF52 turbo, @20.8psi, 280whp, 300ftlbs. (SOLD). CHECK your oil, these cars use it. Engine Build - Click Here Link to comment Share on other sites More sharing options...
Infosecdad Posted August 28, 2019 Share Posted August 28, 2019 Someone didn't happen to connect to the green connectors under the glove box did they? That would do it. Outside of that, what Max said to start with. Link to comment Share on other sites More sharing options...
annie1995williams Posted August 29, 2019 Author Share Posted August 29, 2019 First thing is, step back a minute, go back over all the connections, make sure the big gray harness is fully connected, as well as the grounds are all clean and tight.It was our starter ground [emoji849][emoji849][emoji849] we didnt even touch the starter so we didnt think about it. Sent from my SM-N950U using Tapatalk Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now