tucka Posted August 9, 2020 Share Posted August 9, 2020 Is there anything I should specifically know about fitting the jdm projector headlights into my liberty as in how it is wired in. Link to comment Share on other sites More sharing options...
Brighton96 Posted August 10, 2020 Share Posted August 10, 2020 You will have to do some wiring, the JDM ones have a dedicated high and low beam bulb but most of the other OEM ones use just one bulb for high/low. Depending on your set up, you'll probably have to buy two 9004 male plugs to plug into the stock harness and then split it into two to run both JDM bulbs. Link to comment Share on other sites More sharing options...
ehsnils Posted August 10, 2020 Share Posted August 10, 2020 Since you are in Australia the JDM projector headlights should be fine since the cutoff is for left hand traffic. For right hand traffic then the cutoffs have to be flipped or replaced. It's a good idea to build a split from the original harness instead of cutting the wires in case you want to go back to original. I found this one on EBay: https://www.ebay.com/itm/Conversion-Wire-9004-HB1-TO-9003-HB2-H4-Two-Harness-Head-Light-Adapter-Plug-Play-/141670580689 (Not a 100% match, but can be modified) Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now