Thread: alignment issue
View Single Post
#4: 01-17-2013, 05:00 PM
scoobycoupe's Avatar
Title: Member
Location: Baltimore Metro
Car: 06 Legacy GT
Posts: 155
iTrader: (0)
Send a private message to scoobycoupe Find all posts by scoobycoupe Reply With Quote
Use a tape measure. Measure in an X pattern from fixed points on the body and to the suspension components. Do that on both sides crossing over from left to right and so on. If you measure one side longer than the other something is bent. At that point the hard part is finding the exact part that is out of spec. Good luck!