View Single Post
#10: 12-18-2012, 09:09 AM
Title: Senior Contributor
Location: Waipahu, HI
Car: 2010 2.5i Steel Silver Legacy
Posts: 780
iTrader: (2)
Send a private message to Nacron Find all posts by Nacron Reply With Quote
Originally Posted by 3.6rrrrrmatey View Post
Going to need to be good with Fiberglass. It's a curved surface. The bezel for the headunit will be very small not easy to make.

Edit: Actually it would be very easy to make a mold of the cubby area since you could use the Cubby Lid. Then you would just trim it out and fiberglass that to the bezel included with the headunit.

For the double din spot you could layer blue tape to copy the contour pretty easy I bet.

Maybe something available in Japan??

it's from this 2009 sema one off

It's a one off, but proves single din can be fitted in there.

Last edited by Nacron; 12-18-2012 at 09:14 AM..