View Single Post
#21: 10-18-2009, 09:26 PM
 
 unclemat
Title: Twinscroll troll
Rank: Donating Member
Location: Boston
Car: 05 LGT wagon 6MT
Posts: 12,899
iTrader: (133)
Send a private message to unclemat Find all posts by unclemat
Quote:
Originally Posted by Underdog View Post
Ahh, so since I am planning on stock redline and/or stock clearances, this isn't as much of an issue for me... right?
Well, stock clearances are pretty tight and if you want to push the motor a little bit opening them up while you're there is not a bad idea. But stock will be alright, too. Remember, stock bearings are stupidly expensive, so unless you buy whole new stock short block, you'll be probably looking at aftermarket bearings anyway, and then I am not sure what's the availability of sizes.