Jump to content
LegacyGT.com

rhino6303

Mega Users
  • Posts

    1,573
  • Joined

  • Days Won

    1

rhino6303 last won the day on July 17 2023

rhino6303 had the most liked content!

Personal Information

  • Location
    Vancouver, WA
  • Car
    05 GT Limited

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

rhino6303's Achievements

Veteran

Veteran (13/14)

  • Very Popular Rare
  • Dedicated Rare
  • First Post
  • Collaborator
  • Posting Machine Rare

Recent Badges

123

Reputation

  1. The website doesn't have correct pricing. I paid $615 total in 2020 for the clutch kit (no flywheel).
  2. I use the exedy flywheel. I have less than 15k on the setup since I haven't driven the car in over a year (haven't started/finished the engine build).
  3. I have a zf design full metallic clutch. Reach out to them with and talk and they'll give a recommendation. It was very affordable as well.
  4. https://forums.nasioc.com/forums/showthread.php?p=43568262#post43568262
  5. Can you take a picture of your main engine harness connector by the right side (passenger) firewall? If the connector isn't seated properly, you'll get issues. Can you take a picture of the rear left tgv (driver side)? There should be two main grounds attached to an aluminum post. If these are gone or not attached you'll get issues.
  6. I quickly scanned over this again...did you check the main fuses in the engine compartment (the big ones with clear plastic over the top)?
  7. Need more context here...units? Measuring resistance in ohms or just continuity? 0.8 ohms? 0.8kohms? Are you just using the continuity setting?
  8. Yeah. That appears to just be an aluminum shaft pressed in. I imagine is was an interference fit or has some loctite so a little heat should help.
  9. Yeah. New one is tokyo roki again instead of honeywell. You can get them at walmart now. It's a bit more expensive but easy to get on demand.
×
×
  • Create New...

Important Information

Terms of Use