Jump to content
LegacyGT.com

The_Bishop

Members
  • Posts

    62
  • Joined

1 Follower

Personal Information

  • Location
    PA - South Central
  • Car
    '07 WRX STi

Converted

  • Aim
    mgman72@yahoo.com

The_Bishop's Achievements

Enthusiast

Enthusiast (6/14)

  • First Post
  • Collaborator
  • Week One Done
  • One Month Later
  • One Year In

Recent Badges

0

Reputation

  1. Thanks for this walk-though. Just finished and it took me about 2hrs from the time I stepped in the garage, including the soldering and dust cap alteration, to when I rolled the car back off the ramps. I did it with the front bumper cover in place. Thanks again! - Allen.
  2. I did this mod last night along with installing my RavSpec front lip.. 20min at 200 degrees F worked just fine for softening the housing adhesive. Just remember after you squish the two halves back together to put them back in the oven again for the same amount of time, then press the halves together again to make sure everything is seated well. I got some silicone to put around the seam, but elected not to do it - not sure if I'll regret it or not. It's raining today, so we'll see. BTW, ordered some 3157 bulbs (chrome, blinks amber) from here: http://autolumination.com/titaniumseries.htm - Allen.
  3. Sorry, ment to send a PM...

     

    PM sent. :)

     

    - Allen.

  4. To my knowledge, Magnaflow makes a full CBE for the Legacy, but I'm not aware of them making an Axle-back that bolts directly to the stock Y-pipe as Perrin does. The Magnaflow CBE system's mufflers utilize slip-joint connections that are in a different location than stock. Considering this, I'm not sure that a Perrin/Magnaflow axle-back comparison could be made without some modification to the inlet piping of the Magnaflow system to have flanges added for bolting to the stock Y-pipe. Maybe someone has done it....not sure.. - Allen.
  5. Perrin Axle-back, stock otherwise: [ame=http://www.youtube.com/watch?v=VXDbhWyXmao]www.youtube.com/watch?v=VXDbhWyXmao[/ame] - Allen.
×
×
  • Create New...

Important Information

Terms of Use