Jump to content
LegacyGT.com

kiki86

Members
  • Posts

    7
  • Joined

About kiki86

  • Birthday 01/29/1982

Personal Information

  • Location
    France
  • Car
    Legacy WR 2004

kiki86's Achievements

Rookie

Rookie (2/14)

  • First Post
  • Week One Done
  • One Month Later
  • One Year In

Recent Badges

0

Reputation

  1. I'm interesting, how you manage to flash?
  2. you can't flash (send/read MAP/ROM) with Free SSM, just read diag code and clear memory
  3. You can test this learning procedure: 10.Learning Control A: GENERAL DESCRIPTION Be sure to perform the {Clear Memory 2} only when the following services have been performed. And when the shifting shock is occurred during the total check with vehicle driving, perform the learning with following procedures. <Ref. to 5AT(diag)-17, CLEAR MEMORY MODE, OPERATION, Subaru Select Monitor.> • Replacement of TCM • Replacement of transmission assembly • Simultaneous replacement of TCM and transmission assembly • Replacement of each clutch • Replacement of control valve body CAUTION: When {Clear Memory 2} is executed, DTC may not be cleared. B: PROCEDURE 1) Turn the ignition switch to ON. 2) Turn the air conditioner switch to OFF. 3) Turn the headlight switch to OFF. 4) Turn the rear defogger switch to OFF. 5) Start the engine. 6) Connect the Subaru Select Monitor to the vehicle. 7) Drive the vehicle for 5 — 10 km (3 — 6 mile) to warm up ATF temperature more than 70 °C (158 °F). 8) While checking that the throttle opening angle on Subaru Select Monitor is within the specified range, shift the gear from 1st → 2nd, 2nd → 3rd, and 3rd → 4th, while driving the vehicle at “D” range. <Ref. to 5AT(diag)-15, READ CURRENT DATA, OPERATION, Subaru Select Monitor.> Acceleration opening angle: 12.5% ± 2% 9) While checking that the throttle opening angle on Subaru Select Monitor is within the specified range, upshift the gear from 4th → 5th while driving the vehicle at “D” range. Acceleration opening angle: 15.5% ± 2% 10) Repeat the steps 8) and 9) until the reducing effect of the shifting shock is felt. 11) If reducing of shifting shock is not felt after 5 cycles, recheck that the learning conditions (throttle opening angle, ATF temperature, etc.) are as specified and recheck that other parts are normal.
×
×
  • Create New...

Important Information

Terms of Use