Jump to content
LegacyGT.com

subaru-tech

Members
  • Posts

    43
  • Joined

About subaru-tech

  • Birthday May 20

Personal Information

  • Location
    Drums pa
  • Car
    2005 lgt, 2019 silverado
  • Occupation
    Subaru Sr. Master technician

Converted

  • Icq
    1983

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

subaru-tech's Achievements

Contributor

Contributor (5/14)

  • Dedicated Rare
  • First Post
  • Collaborator
  • Conversation Starter
  • Week One Done

Recent Badges

9

Reputation

  1. So I'm going to be lowering my daughter's outback after winter. I'm wondering what a good offset for flush wheel fitment would be. I currently run a +48 on my lgt and my wheels sit pretty flush. I'm worried about being flush on the wider body and rubbing the wheels. Pics are also welcome for her to see what wheel style she may like. Thanks!!!! Pic of my car.for attention lol.
  2. That's the part of the crankshaft that the front crank seal in the oil pump seas against.
  3. If you have a sunroof, it is possible the drain is blocked or came off the sunroof
  4. So for some reason on these generation legacys when you get abs codes, especially on automatics it causes them to run terrible and they kick the fans on too. Now on subarus there's 2 terminating resistors for the can network. One in the ecm and one in the vdc. You can use pins 6 and 14 of the dlc connector to.check the can network. You should get 60 ohms with everything plugged in, if you ger 120 ohms youve lost a terminating resistor. My guess by the symptoms your having is the vdc module took a dump and is messing with the can network. This is where I would start.
  5. General (with brand new cast iron) they will smoke . Your burning the oil and impurities off of the metal. I've put quite a few new turbos on to have them do this. It will stop when all the impurities are burnt off.
  6. I usually use a jack.and block of wood under the front diff.
  7. Sounds like the fan motor is shot. If you have to push the fan to get it going, the brushed are probally bad.
  8. I know, I order a lot of parts from him. Top quality
  9. When I did my swap I used a 2015 sti power steering pump. The pressure is a little higher and aids in the judder when turning fast
  10. www.mysubieparts.com has one for sale right now.
  11. I'm intrested but have to wait 2 more weeks for taxes
  12. That kit is perfectly fine. You'll notice a difference with the lighter flywheel too. This is the kit I went with because of the mods I have and am planning to do. https://www.importimageracing.com/products/sb11-hdss-act-heavy-duty-street-sprung-clutch-kit-w-flywheel-subaru-wrx-2006-2021?currency=USD&variant=44929130131&utm_medium=cpc&utm_source=google&utm_campaign=Google Shopping&gclid=CjwKCAiAy_CcBhBeEiwAcoMRHIFpXuGHepdiruxFBQ5uRSVnPcM8J4wdVSvtGSQXF2aBZcc4YM2aMRoCTAcQAvD_BwE
×
×
  • Create New...

Important Information

Terms of Use