Jump to content
LegacyGT.com

05leggtlimited

Members
  • Posts

    31
  • Joined

Personal Information

  • Location
    Western ma
  • Car
    05 BSM Stage2+

05leggtlimited's Achievements

Explorer

Explorer (4/14)

  • First Post
  • Collaborator
  • Conversation Starter
  • Week One Done
  • One Month Later

Recent Badges

0

Reputation

  1. Shot in the dark for an old post but is that factory ride height or do you have springs?
  2. installed axle shaft today. A note I would like to add for the New England guys if it hasn't been mentioned already. soak your bolts previously! The balljoint pinch bolt sheared on me. drill swear repeat. note :You can drill from the back side with a straight shot if you remove caliper. In removing the balljoint I cracked the knuckle. DO not use a chisel to spread the knuckle or be very gentle. In all this horsing around the balljoint with 114k failed. Long story short, 1 balljoint, 1 knuckle, 1 end link that was also frozen later its back together. Be methodical and work slow, stuff breaks if not. hope this helps someone to avoid my situation.
  3. look into the hex mods thread, by the sounds of it he is no longer making valve bodies unfortunately but there is a lot of valuable 5eat info there
  4. this just saved me a ton of time and frustration! Thank you! I have a bad left front axle shaft and a replacement in the trunk. Prodemand instructions have you undoing strut bolts, pulling wheel speed sensors etc etc. The less you take apart the smaller chance of error.
  5. No mines silver on gray wrx wheels. I think I know who you saw though
  6. Lee Ma, commuting to Springfield tech
×
×
  • Create New...

Important Information

Terms of Use