KRYPTO

yes. you can drive it onto a trailer and stuff to get it in for dyno tuning if that's your plan

Where did you get your vf52? I'm looking at upgrading mine also. ebay has reman ihi ones for $400 but always weary of those lol

I searched JmP and it said he hasn't been online since 2016??? I've been looking at getting a vf52 also, ebay has reman ihi ones for $400.... Are those any good or do we want to make sure the cartridge is OEM?

there will be some oil in there from normal blow by from engine/turbo, if its excessive could be turbo going out or pcv issue

Is there a sticky that I'm missing or a web link that shows all the specs for rebuilding the Subaru engine? I'm starting from a short block ej255 so anything before that isn't needed. Thanks

How do you install wideband for AP data logging to get etuned?

didn't find anything in his thread or other threads he has done. Did find the evap removal and will be doing that. I'll have to message him or cryo on the wideband datalogging. I'm pretty sure I'll have cryo retune car with etune

Did not receive pm. I also don't have any sent messages for some reason. Maybe an mod or ad can help?

It's a Subaru, there are no "cheap" mods lol I would start with what Max Capacity mentioned although an oil analyses might be a little over kill unless there is know issues or any components such as turbo or internal failure have occurred in the past. The usual bolt-ons will do but first get yourself an Accessport before any motor related mods

So after 6mnths the motor is finally getting put back together and into car. I sold all my upgraded turbo and fuel stuff and will be sticking with the stock vf46 that was in it (as the turbo wasn't the issue) I will however be putting in the tgv deletes and air pump delete. I'm sure I'll need to retune for those removals and will need to install a wideband for logging and etune. How do I install the wideband and connect it to the AP for datalogging? My DP has a o2 port right behind the turbo, would that be efficient as location and leave the factory o2 in place and connected farther down the DP? Thanks

Turbo inlet hose?

Interested in the Turbo inlet hose

I have one. Hasn't been bolted on since fully ceramic coating $200

I removed the rubber insert on mine once I noticed rust under the paint. Damage was already done and kept getting worse. They don't make replacement panels for these. I'm in the same issue here in MN, the rust cancer is on every Subaru wheel wells here and. I'm down to a selling price of $5k for my '07 lgt manual and my rust isn't even that bad. It's the typical Subaru community wanting to pay dirt bottom to buy and asking full new retail to sell lol

Looking to get car back to stock. In need of Stock downpipe Stock Radiator Complete set of working heads that I can bolt on and go. All parts are for a '07 lgt 5mt Thanks