upper console off, dashboard on, center console on
my mechanic says he has software that can pull the airbag fault and he says it's the passenger side that is coding and is part of recall.
i pulled the board anyway and found that my board only has one LED, the other 3 slots are empty. it looks pretty stock. also there are only two wires to the board - red and blue. the foam around the connectors all looked intact. i was wondering if someone already had a go at it. i reflowed everything and nothing happened. i am going to try it again....
update - after two tries, still no good. i paid attention to the 511 resistor and the diode this time, to no avail...