Jump to content
LegacyGT.com

Harsho1

Members
  • Posts

    64
  • Joined

Personal Information

  • Location
    Fort Wayne, IN
  • Car
    '05 Legacy GT limited
  • Interests
    Fast Cars, Fast Computers.
  • Occupation
    Auto Parts Counterperson

Harsho1's Achievements

Enthusiast

Enthusiast (6/14)

  • First Post
  • Collaborator
  • Conversation Starter
  • Week One Done
  • One Month Later

Recent Badges

0

Reputation

  1. On the sedan, it is located behind the C-pillar trim on the passenger side because it uses the rear defroster grid as the antenna
  2. Yes. It is directly above the oil dipstick, and A/C compressor clutch wire in this picture.
  3. looking for one of these clips. Of course they are discontinued from Subaru. It attaches to A/C compressor bracket and holds main alternator harness.
  4. I am in the middle of putting my 05 back together with the Perrin inlet. I had a HUGE problem with their provided PCV connector as It was twice as tall as the factory one and then had the electrical connector on the top, instead of the side. There is NO WAY it was going to fit under the intake. I ended up cutting the factory one out of the old inlet tube and adding a 1/2" nipple to the bottom of it so I could use it on the Perrin tube.
  5. Looking to install a remote start in my '05 LGT but don't really want to cut any underdash wiring. Any one know of a source for male and female connector sets for i84 , B280 , B281 , B69 & B72 connectors?
  6. In the pictures i have seen, it appears they have moved to using a framed door window instead of frameless like on my fourth gen. This should help with wind noise immensely.
  7. My old lca's were original, and bushings were torn in half, so I noticed a HUGE improvement. Since I paid less for both LCA's than I would for one bushing it was worth it.
  8. So... has anyone actually installed these yet? I am still saving up for swaybar endlinks, and cv axles.
  9. Looks like carid fixed or ended all their ebay auctions too. Seems now best price for these is rock auto at $106 ea.
  10. My UPS tracking shows I should have them tomorrow. Will post pics A.S.A.P.
  11. The eBay post in op lists fitments on some Ford transit connect so I think they have a listing error. The part number listed is for LGT lca but their information is for some Ford part that only lists for $5.00. My two arms shipped in one box that ups says weighs about 19 pounds.
  12. So... My lca bushings have been getting a little sloppy and I had been saving up for new bushings...I had wished I could afford the spec-b arms, but at over $300 a piece that was WAY out of my budget. Then I found some on rock auto that are spec-b style for only $106 ea. Jackpot!!! Then I thought I would double check E-bay to see if I could find them for cheaper. -WOAH- http://www.ebay.com/itm/Mevotech-CMS80182-Control-Arm-and-Ball-Joint-Assembly-Brand-New-/231689645859?vxp=mtr I don't know if this is some kind of typo but I ordered both sides (cms80181 is other side). their listing says it fits a ford transit connect, but on rock auto it fits LGTs, also picture looks like a spec-b style arm. So in conclusion, I got TWO front spec-b style LCA's for $45.00 shipped. yes $45.00 for BOTH with SHIPPING! I should have them on thurs. the 18th and will post results.
×
×
  • Create New...

Important Information

Terms of Use