Ilubeyousubaru

So I ended not having to double up on the 3/4". I got the stenciling done and jigsawed the pieces, done by 11 pm. Took about a total of 4 hours. I will take pictures of the stencil for whatever it's worth. If you are going to make your own stencil. I recommend using cardboard that is atleast 2-3 layers thick. I say this because on the top hat, the center rubber grommet flairs inward into the base that makes it hard to center and stencil. I eyeballed everything. Also over size all holes a bit. It's an easy job with a decent impact wrench and a helper.

Would you be open to making the holes elongated with a dremel? I couldn't find anything in regards to adjusting it in the body repair manual.

All the options I could find pointed me to do this as a DIY. I ended ordering a sheet of HDPE 3/4"x12"x12" sheet from McMaster for $21. I'm going double up on the layer and fabricate it where the one layer that will sit on the top hat will have the hole in the middle and another layer on top of that without a hole in the middle. I will try to remember to take pictures for future reference.

Does anyone have the template to the rear spacers?

I recently put a hitch on my 2008 2.5 Legacy 5 spd and was wondering what are my options to raise the back so I get more clearance when towing my jetski and stop getting weird looks. Total weight of towing is around 1100 lbs and tongue weight is about 120 lbs. My friend suggest air shocks, I don't think that would work with coil overs. I have stock rear suspension that are already sagging and was wondering if spacers would get me by. Can someone recommend me some spacers? The driver's side rear sags a bit more.

It looks like you tried closing the trunk while something in between it. I did the same with something on the side and mine leaks driving in the rain because of it.

I have a 2008 Subaru Legacy special edition, and I tore up the trunk of my car to look for the T Connector. It was nowhere to be found by sunset and I gave up. I purchased the Hopkins 23855 on because of the manufacturer stating that it is a direct fit. Does anyone know where this hidden T connector is? I have Chiltons manual and I am thinking I will have to splice wires but the male connector hase six connections and the subaru oem female has 5/6...

They diagnosed it as the overhead console. Subaru is covering this repair as a one time courtesy.

Anyone have any issues with the light coming on after the takata recall service? Mine is on intermittenly after I had it serviced.

[ame=http://www.amazon.com/LT-Sport-100000000139-205-Multiple-Aluminum/dp/B00RW4O8TG/ref=cm_cd_al_qh_dp_t]Amazon.com: LT Sport SN#100000000139-205 For Multiple Vehicle Aluminum Roof Rack Sedan Coupe Top Cross Bars: Automotive[/ame] Any inputs on these? Sounds too good to be true. I want to put a 16' tandem fiberglass kayak on it.