GizzXT

So I finally had a smoke test done at a local shop, with no results. I was checking over the connections with a mechanic when I noticed air coming from the where the turbo and up-pipe meet. The mechanic wasn't sure if that would effect the a/f ratio or not? If so, would probably need a new gasket? aftermarket up-pipe and turbo btw.

I've put on about 75 miles since I reset the ecu when I replaced the rod knock sensor fwiw. Thanks for the link.

I'll have to check the maf and filter before one last thorough look over. Don't know the last time they've been cleaned. Thanks for the feedback.

Alright I guess it could be worse then. I've tried every connection that I could think of. Do you think doing a smoke leak test would be wise?

So I couldn't get RR to work so I used learning view v1.0 rc3. I have no idea what I'm looking at, but i'm guessing the red isn't good. Any feedback would be much appreciated. Thanks in advance.

Thanks!

Installed ecu flash. Open RR logger, says I need car and logger definitions. So I Install them both. Still says the same thing when I try it again. What am I missing?

I've downloaded Romraider now. Do I need to install ecu flash, logger, just to use the learning table values tool? Is that what you meant by associated drivers? I believe I'm using a Tactrix OpenPort cable. Thanks

Thanks for the reply. So I downloaded learning view v1.0 rc3. When I plugged into the car, nothing came up under port. Do I need to download anything else? Not sure what kind of cable I have either, came with the car. Complete noob.

A/f bounces from roughly 15.2 to 15.8 at idle when warm. Sticks right around 14.7 when driving normal. No cel for running lean. Did replace my rod knock sensor recently so I was thinking a lose hose somewhere. Checked all my connections to the best of my ability with no luck. Tried carb cleaner around manifold, bov etc. Not sure if it's a air leak now or not. Any ideas?