I bought a GlowShift boost gauge from a member here, and I just have a few questions about the installation process. I'm going to mount it on the steering column when I get the pod I need. Where do I need to run the wiring? What do the wires connect to? It has an orange, a red, and a black wire. I also want to follow M Sprank's advice and T off the MAP sensor for the vaccum line. Someone said there is a grommet in 5EAT cars where the Clutch Master Cylinder would go, if it were a manual, that I can run the vaccum line through. I have no idea where it is lol. I've looked around a lot for a step by step guide but wiring is something I have no comprehension of. Just looking for tips from someone who has installed a boost gauge on their steering column.