Just got my car back from the shop (blown turbo and full engine rebuild) and working with Dave at CryoTune when i try to access my ECU with romraider i get the error that i cannot connect to it. i can pull the simple data in learning view but cannot download anything with romraider or ecu flash. i am new to this type of tuning used a Utech in my WRX. but from what i can gather the ecu may be flashed and i am guessing this way due to the CEL has not come on while it was out of commission i also installed a Catless DP the car has close to a 100 miles on it and the CEL has yet to come on for the O2 sensor. so my question is if it is a locked ECU via Cobb V2 is there anyone out there that would let me marry there cobb to my car and remove the tune and put the stock tune back on so that i can continue working on my open source tune. i am down in Salem, and would be willing to drive up or down the 5 to meet up with you in Portland or Eugene. from what i have read only Cobb and EcuTek locked the ECU and i see the Perrin shop in Hillsborough is a EcuTek tuner so if the cobb does not work i may have to pay them a visit.