TcDavis Posted October 23, 2012 Share Posted October 23, 2012 Getting ready to put amp on my door speakers but want a little advice on the easiest way to run wires from speakers to amp. Suggestions greatly appreciated. Im running a Kenwood DNX7280 head unit, pork audio mids (for now). Tc Davis Link to comment Share on other sites More sharing options...
captainobvious Posted October 23, 2012 Share Posted October 23, 2012 Use the wires from behind the radio and then run your wires down the passenger side of the car. Run the power on the opposite side to reduce engine noise. Link to comment Share on other sites More sharing options...
TcDavis Posted October 23, 2012 Author Share Posted October 23, 2012 Kinda what i thought i could do. Thanks:D Tc Davis Link to comment Share on other sites More sharing options...
luvracn Posted October 24, 2012 Share Posted October 24, 2012 depends on what kind of power your going to push. You can use the factory wiring to cheat and splice into going to the doors or run new, which is what i always do. It's more work running new wires through and out into the doors, but in the long run, it's much better when pushing any more power to nicer speakers. Your choice and just my opinion. DO separate the power wire away from speakers to avoid the "whine" noise. Link to comment Share on other sites More sharing options...
TcDavis Posted October 24, 2012 Author Share Posted October 24, 2012 Use the wires from behind the radio and then run your wires down the passenger side of the car. Run the power on the opposite side to reduce engine noise. After harness or before? Tc Davis Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.