Originally Posted by bnguyenbb6
According to the V1 AP, it was divorced. Which target tables does Cobb use? Do they show up in romraider or ecuflash? He said that we are stuck until I can wipe the tables. Will marrying a V2 AP and divorcing it work?
it is a mix, but I think boost uses the AT boost target A instead of the MT boost target B. when the V1 divorces it will likely have written a modified A2WC510N map to the car, with the tables modified with stock values. the logic still uses the wrong tables but Cobb has also gone and modified the table contents to match this. the V1 doesn't really revert to stock when you ask it to.
A couple years back I did some experiments to figure out which tables were used, but I don't have all the mapping with me. Basically I used the AP to write known values to the tables and then took a dump before and after divorcing the AP. IIRC I filled each table with an obvious value (all 1, all 2 all 3 etc....) then took a dump.