Alignment issues

Ok so I have a 08 LGT and I hit a curb with my drivers side front wheel I had the struts replaced, lower control arm replaced and just replaced the wheel bearing. I got an alignment and I couldnt get the negative camber I wanted on the side I hit because something was off. The car is zeroed on both sides but where the camber plate sits on the drivers side is maxed out and the passenger side is less than halfway as I have bc coilovers. Want to know if anyone could help me out and figure out what the problem still is? Could it be my rack and pinion? Front crossmember looks ok. Any info will help thanks

the top strut bolt on the coilovers have some camber adjustment to it...

But the bolts should still be even on both sides on the camber plates if they are at the same camber readout on the machine. U no?

no, look at the strut bolt, not on the camber plate, but down by your hubs

Ok I will tomorrow when it's bright out already dark over here on the east coast

top bolt should have a oval shape to it...