sashadg1 Posted March 17, 2013 Share Posted March 17, 2013 Can someone direct me to a thread that lists all the springs and how much they lower the car. I have swift wagon springs but would like to go a little bit lower, just to much gap still. Anything out there that will go 1.75 or so? I have Bilsteins Thank you, Scott Link to comment Share on other sites More sharing options...
rhino6303 Posted March 17, 2013 Share Posted March 17, 2013 Did you check the "Lowering Springs Mega Thread" that is on the page? It doesn't list specs but it does have pics of pretty much every spring combo you can have installed. Link to comment Share on other sites More sharing options...
sashadg1 Posted March 17, 2013 Author Share Posted March 17, 2013 Is there a way to remove or trim down the rubber spring isolator on the front Springs. Also has anybody used ground control to modify current struts into coilovers. Link to comment Share on other sites More sharing options...
sashadg1 Posted March 17, 2013 Author Share Posted March 17, 2013 Yes I read the mega thread unfortunately very time consuming and didn't provide information I was looking for. I remember a long time ago there was a thread listing all the springs and the specs. Link to comment Share on other sites More sharing options...
sashadg1 Posted March 19, 2013 Author Share Posted March 19, 2013 Looks like the S-techs are the lowest, however, I had the H tech which are not as low and ride quality was nothing to sing home about I cannot imagine how bad the S-tech ride is. Anybody have them with Bilsteins? has anybody thought about shaving down the upper spring isolator pad? I just need about a half inch, even a 1/4 would be good. Then I could remove the rear doubled up pad. It is the front that is too high..... Link to comment Share on other sites More sharing options...
sashadg1 Posted March 19, 2013 Author Share Posted March 19, 2013 anybody have a schematic of the spring and strut assembly? Link to comment Share on other sites More sharing options...
Dbl_D718 Posted March 19, 2013 Share Posted March 19, 2013 http://legacygt.com/forums/showpost.php?p=2627431&postcount=19 MODS: PW TMIC, Cobb catted DP, HKS cat-back, AVO filter, Bren e-tune; Konis/Epics, Advan RCII Link to comment Share on other sites More sharing options...
sashadg1 Posted March 19, 2013 Author Share Posted March 19, 2013 You are the man that's what I was looking for however I know my front end is not 2 inches down from stock. I have swift springs I have a 2 finger gap in the front running Bilstein struts with SPECT B top hat. Thanks again Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.