Spec-B GT Posted February 10, 2007 Share Posted February 10, 2007 I know this may seem dumb to others but the only thing dumb is not asking the question:) I have a brembo cross drilled rotor that I had on my GTI its fitment is 5X100, I tired it on the other day and it has an issue; the hub is bigger than the stock legacy rotors, is there a spacer that i can use to make it fit? or bigger hub nut (axle). Aftermarket Slotted & crossdrilled & zinc plated 312x25mm brake rotors OEM ECrotor design 1 piece 2 piece floating vane design straight 32 - high efficiency airfoil design 12.3" - 312mm 25mm diameterthickness 26mm weight / side 17.5 lbs 13.5 lbs (23% lighter than OEM Link to comment Share on other sites More sharing options...
edmundu Posted February 10, 2007 Share Posted February 10, 2007 It would be much smarter to sell them on the Vw boards, and pick up LGT specific rotor's. Also, from the specs, they are all wrong, from the smaller diameter, narrower thickness, and likely not correct offset. Link to comment Share on other sites More sharing options...
red beast Posted February 10, 2007 Share Posted February 10, 2007 It would be much smarter to sell them on the Vw boards, and pick up LGT specific rotor's. Also, from the specs, they are all wrong, from the smaller diameter, narrower thickness, and likely not correct offset. +1 how much is your life work if they fail after a jury-rig? Link to comment Share on other sites More sharing options...
Spec-B GT Posted February 10, 2007 Author Share Posted February 10, 2007 ^^^ yeah i know but I love them so damn much. Does brembo makes any of the legacy?? Link to comment Share on other sites More sharing options...
red beast Posted February 10, 2007 Share Posted February 10, 2007 something like this? check with the lgt venders http://www.thekingofparts.com/servlet/Categories?category=Legacy+05-07%3ABraking Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.