DJ DJD Posted December 21, 2013 Share Posted December 21, 2013 Hello, I have a stage 1 OBXT. Sometimes the idle is rough. I know my TGVs occasionally act up but I have been messing around on my AP and don't really know whats a good RPM to set the idle at? Any recommendations? It seams too low at stock but vibrates any higher? Thanks for the help mates! Link to comment Share on other sites More sharing options...
iNVAR Posted December 21, 2013 Share Posted December 21, 2013 If you're not able to run properly with idle at stock settings, something else is wrong. Leave it at 750. Or at most 850. Link to comment Share on other sites More sharing options...
McDowell Performance Tunin Posted December 21, 2013 Share Posted December 21, 2013 What intake are you running and is it factored into your tune? www.facebook.com/mcdowelltuning [sIGPIC][/sIGPIC] Click Here for Stage1, Stage2 and Stage3 Tuning and eTuning Info Link to comment Share on other sites More sharing options...
xt2005bonbon Posted December 21, 2013 Share Posted December 21, 2013 What intake are you running and is it factored into your tune? Link to comment Share on other sites More sharing options...
DJ DJD Posted December 22, 2013 Author Share Posted December 22, 2013 A cobb sf with the heat shield. I threw a p2016 cel code the other day? Possible tgv issue? Link to comment Share on other sites More sharing options...
DJ DJD Posted December 22, 2013 Author Share Posted December 22, 2013 Sorry and yes I am running the off the shelf 91 octane stage 1+sf map. Link to comment Share on other sites More sharing options...
cryo Posted December 24, 2013 Share Posted December 24, 2013 A cobb sf with the heat shield. I threw a p2016 cel code the other day? Possible tgv issue? its Very possible . Like mentioned above you should not need to adjust your idle at your mod level. Dave [sIGPIC][/sIGPIC] Providing unmatched customer service and a Premium level of Dyno/E-tuning to the Community cryotuneperformance@yahoo.com facebook.com/cryotuneperformance. Link to comment Share on other sites More sharing options...
DJ DJD Posted December 24, 2013 Author Share Posted December 24, 2013 Alright, thanks for all the input from everybody. I'll dig deeper into it. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.