Squiden Posted September 7, 2012 Share Posted September 7, 2012 Anyone have a spare threaded arm for an AVO wastegate actuator? I managed to snap mine in half while adjusting it . I tried the JB Weld route, but there just isn't enough material to get a clean bite (snapped right at the end of the threaded section). Any help would be appreciated! Link to comment Share on other sites More sharing options...
.Catalyst. Posted September 7, 2012 Share Posted September 7, 2012 I do - sending PM now. My spec.B [#163] Project Thread with Pictures Get CryoTuned! Link to comment Share on other sites More sharing options...
Squiden Posted September 7, 2012 Author Share Posted September 7, 2012 Thanks to Catalyst for hooking me up! Link to comment Share on other sites More sharing options...
.Catalyst. Posted September 7, 2012 Share Posted September 7, 2012 Glad I could help! It's shipping out today - tracking to follow. My spec.B [#163] Project Thread with Pictures Get CryoTuned! Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.