Jump to content
LegacyGT.com

Feeler: Cleared HID headlights. RX300 nonAFS projects, Volt Ballast, Phillips D2S


rkl303

Recommended Posts

I got into an accident where the other driver hit my driver's side rear door and not sure if its called the rear fender but I fishtailed and slammed the other side into a light pole.

 

Anyways assuming my car is totaled I believe I the right to swap my aftermarket parts for OEM parts. I doubt I will have much time to perform the swap so I think its a whoever can make that specific time basis so there are no dibs but if you are interested I'd be willing to swap your OEM for my modded headlight + some cash (I'm thinking 100 or 200).

 

The good:

*Volt HID Ballasts

*Phillips D2S bulbs

*RX300 nonAFS projectors with LGT lenses

*Removed amber part of turn signal

*Syvanila/Philips turn bulbs that have purple chrome look that blink amber

*Painted some of the chrome part of the signal indicators(you should be legal as there is still plenty of chrome to reflect the amber bulb)

 

The bad:

Some scratching that should/could be polished out

I bought the headlights from a FS section and it looks like they cut out a .5"x.5" notch in each of the housings so that they could route (possibly HID wires out of the headlight, which wasn't necessary to do). Because of this there is some condensation that will occasionally appear in the headlights but you could probably seal this gap with some tape.

 

I have other parts but I will post those in the FS section later since I have the OEM parts.

 

Hopefully I can find pictures of my headlights as modded.

 

Richard

1557450052_2011-05-1312_57_27.jpg.aa3f75cc317267d1fa97d3ee7be5e537.jpg

685810377_2011-05-1312_57_37.jpg.e7f7778041987a24913aec55a8b64c23.jpg

1295380625_2011-05-1312_57_52.jpg.aaae945f9fb8d3802c3d49a84228d860.jpg

Link to comment
Share on other sites

Not sure. I'll either be ending up with an STI or 05 lgt MT limited wagon so I may be parting what few parts are available or I might be keeping them.

 

In either case I'd be keeping the downpipe and short air intake.

Link to comment
Share on other sites

I'd be interested in swapping my oem front bumper for your oem front bumper and some $. I think someone backing into my front bumper and cracked it in a 2x2 inch area, would be cheaper for me to swap the bumper vs fixing it. Let me know if you interested.
Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.



×
×
  • Create New...

Important Information

Terms of Use