Bolksey85 Posted June 3, 2013 Share Posted June 3, 2013 Between a Magnaflow and now being lowered on the usual Koni/Epic combo, I get a squeaking from at least one heat shield in the rear. I trimmed one before with tin snips where it was rubbing through but now more have appeared. It only does it at a fairly low RPM and low speed from what I can tell but it is annoying. Can I just throw some self tappers into them and be done? Or will I risk damaging something important? Link to comment Share on other sites More sharing options...
sheppo9 Posted June 4, 2013 Share Posted June 4, 2013 Just take it off. Link to comment Share on other sites More sharing options...
Bolksey85 Posted June 4, 2013 Author Share Posted June 4, 2013 Just take it off. It won't cause anything to get too hot? Link to comment Share on other sites More sharing options...
c-lo Posted June 5, 2013 Share Posted June 5, 2013 mine are rattling up front by the oil pan. 258k miles - Stock engine/minor suspension upgrades/original shocks/rear struts replaced at 222k/4 passenger side wheel bearings/3 clutches/1 radiator/3 turbos Link to comment Share on other sites More sharing options...
sheppo9 Posted June 5, 2013 Share Posted June 5, 2013 It won't cause anything to get too hot? Not at the back/centre it won't. If they where the header heat shields thou, I'd leave them on or get wrap. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.