Jump to content
LegacyGT.com

AT transmission for drag race and daily use


Tomcat

Recommended Posts

Just simple question... are there any AT transmission suppliers for my needs?? I know Rigoli have some options years ago, but on my taste they are bit too race.

 

How about markets in these days??

 

Electronic shift option would be nice and flappy pedals to steering wheel too...

 

Tranny must handle least 600hp / 550ft/lbs

Link to comment
Share on other sites

A 600HP automatic daily driver? Is this for a Subaru?!?

 

Yeah... Now 1.5Bar boost 545hp/712nm ( 2.5L )

 

New strong short block 2.35L are coming and then we gona take 1.5bar with sport and 2.0bar with sharp sport :lol:

 

 

http://www.saunalahti.fi/boiv/Sekalaiset/Cosworth%20engine.jpg

Link to comment
Share on other sites

Before you go further, have you considered picking up a MT Legacy, say a 2009 6MT Spec.B? The reason I ask is that although what you ask for is doable, the options of strengthening the AT are much more limited than what you can get with a MT.

You gotta think about the rest of the drivetrain too. Rear and front diff. You can do all sorts of swaps on a MT, not so much on AT.

Link to comment
Share on other sites

:lol: Yeah I know... Well this AT goes to my next project.

 

Sleeper Fore.

 

( Stock look with beast heart )

 

http://www.goodhousekeeping.com/cm/goodhousekeeping/images/uS/subaru-forester-mdn.jpg

 

We buy wrecked STi and swap all to this granny forester...

= +600hp smoker

It would be nice to smoke almost all you faced in lights :lol::lol::lol:

Link to comment
Share on other sites

Make sure you talk to ClimberD and frankster, they are the resident 5EAT experts.

 

Hexmods F1 valve body, upgraded center differential would be the starting point. You're in pretty uncharted territory for a 5EAT though, so you may be replacing a lot.

Link to comment
Share on other sites

Might want to pm frkkevin.

 

He is probably pushing the most whp for an auto. He was going to run his car in the Texas mile.

 

He had IPT build his tranny, but ended up having to get a ClimberD valve body as well when it started slipping.

 

Another poster seemed to indicate that IPT was now using a TransGo like kit in their VB now too (instead of the $0.50 spring they used to charge $769 for :lol:), so maybe their builds are a little better now.

 

http://legacygt.com/forums/showthread.php/dyno-vid-177909.html?t=177909

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.



×
×
  • Create New...

Important Information

Terms of Use