SKYravefever Posted December 24, 2009 Share Posted December 24, 2009 Looking for some help in figuring out how to wire up my HID kit. It sounds like I need a relay harness, especially if I want to retain the original headlamp socket/plug. Where does 1, 2, & 3 in the below picture go? Or do I have the wrong harness? It's going to be hooked up to a pair of Denso Slim ballasts, attached. Link to comment Share on other sites More sharing options...
JaeGT Posted December 24, 2009 Share Posted December 24, 2009 there are PLENTY walk-throughs for HIDs....... but here... 1, 2 are to plug into the ballasts. 3 is to go into the oem harness inside the weather grommet of the driver side. search before you post Link to comment Share on other sites More sharing options...
SKYravefever Posted December 24, 2009 Author Share Posted December 24, 2009 Thanks for the help. It looks like I need to clip the connectors on the harness since the ballasts do not have male connectors for power.Believe me, I've done hours of reading on this board before asking, but couldn't find anything specific to the harness & ballast's power delivery. thx again. Link to comment Share on other sites More sharing options...
king_j Posted December 26, 2009 Share Posted December 26, 2009 there are PLENTY walk-throughs for HIDs....... but here... 1, 2 are to plug into the ballasts. 3 is to go into the oem harness inside the weather grommet of the driver side. search before you post post a thread showing a walkthrough using a harness. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.