black318i Posted March 18, 2009 Share Posted March 18, 2009 I’ll be taking my car to get worked on and I wanted to create a valet map in RomRaider and I’m not sure how one is set up. Any advice would be appreciated. Can I keep my stage 2 mods on? Thanks http://i124.photobucket.com/albums/p38/mrsalty75/accident/IMG00026-20090317-1619.jpg Link to comment Share on other sites More sharing options...
mickeyd2005 Posted March 18, 2009 Share Posted March 18, 2009 Just cap your requested torque DBW table at 200. Link to comment Share on other sites More sharing options...
black318i Posted March 18, 2009 Author Share Posted March 18, 2009 Awesome thanks Link to comment Share on other sites More sharing options...
snow05gtRI Posted March 18, 2009 Share Posted March 18, 2009 damn! you get sat on by an elephant or something? Link to comment Share on other sites More sharing options...
black318i Posted March 18, 2009 Author Share Posted March 18, 2009 Full size ext cab Chevy PU. A lady turned left accross my lane all of a sudden. Looked like she was about to miss her turn and decided to go for it at the last second. Only thing is she wasn't in a turn lane. Link to comment Share on other sites More sharing options...
black318i Posted March 19, 2009 Author Share Posted March 19, 2009 Just cap your requested torque DBW table at 200. Should I use my stage 2 map to do this or stock or does it matter? Link to comment Share on other sites More sharing options...
mickeyd2005 Posted March 19, 2009 Share Posted March 19, 2009 It doesn't matter. You might want to set a 5000 rpm redline too. Link to comment Share on other sites More sharing options...
black318i Posted March 19, 2009 Author Share Posted March 19, 2009 Good call and thanks again Link to comment Share on other sites More sharing options...
BLKGT5 Posted March 19, 2009 Share Posted March 19, 2009 IMHO I would set target boost levels to zero and set rpm limiter to 3500rpm. But if they unplug the battery, then it would reset those settings unless you reflash the ecu. Link to comment Share on other sites More sharing options...
mickeyd2005 Posted March 19, 2009 Share Posted March 19, 2009 IMHO I would set target boost levels to zero and set rpm limiter to 3500rpm. But if they unplug the battery, then it would reset those settings unless you reflash the ecu. It doesn't matter because target boost is is already < 2 psi at partial throttle. It's lower than the TD threshold so once you are below the target boost threshold, the WGDC is always just equal to WGDC initial. black318i uses opensource so I'm assuming he's talking about a reflash. Link to comment Share on other sites More sharing options...
tingtang Posted March 20, 2009 Share Posted March 20, 2009 i need to set something up like this on my car... i got my alarm installed at quality auto sound.... and when i got my car back they drove .5 miles... which i kno isnt a WHOLE lot... but i kno that all .5 miles of it was WOT redline... Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.