Thread: Car PC
View Single Post
#15: 01-15-2007, 05:42 PM
 
 f1anatic
f1anatic's Avatar
Title: Das Cruise Meister
Location: Chicago
Car: Legacy GT & Forester XP & Jeep GC
Posts: 8,221
iTrader: (5)
Send a private message to f1anatic Find all posts by f1anatic Reply With Quote
I have some trouble getting the OBD-2 feature to work with Centrafuse. I use the Cobb AP with a serial-to-usb converter. The solution is good enough for TARI DataLogger (it works). Nighthawk and I tried for 1 hour to make it work tonight and to no avail.

Display Name - OBDII
COM PORT - COM4 (for me, the same port used by the Tari Racing Software)
BAUD RATE - 9600 (we tried the lowest, the highest - did not work)
OBDII DEVICE - ELM 320,322,323 or ELM 327 (which one; tried both did not work).

In the end, all it did say was connecting. But it was saying that for far too long, with engine running...so I know it did not work. Advice needed. Thanks.