View Single Post
#337: 01-27-2014, 02:43 PM
fredrik94087's Avatar
Title: Uber Ogre
Rank: Premium Donator
Location: My Own Little World
Car: Fiona-Pearl
Posts: 4,815
iTrader: (5)
Send a private message to fredrik94087 Find all posts by fredrik94087 Reply With Quote
Originally Posted by Brent C View Post
Thank you! I am not sure on the weight, but they feel pretty close to stock so not light by any means. You can order the M590's in custom width, offsets, and bolt patterns now. I think they call it the Bespoke program. I might just mess around with a regular hair dryer and a rubber mallet tonight. Take it nice and easy and see how it goes. If I get to nervous then I will just stop and find a roller. lol.
I wish I would have gone with like a +45 offset, then I could go super low and not even have to worry about rolling fenders at all. It should look good when I am done though, well if all goes well, haha.
Just pull the front carefully. They will crease/fold if not careful.
"It's within spec" - SOA
"Depth is only shallowness viewed from the side." - Fredism
"So, how much did it cost for your car to be undriveable ." - Stephen (very close friend)
"You have done so much it would be stupid to go back." - Sunny of Guru Electronics

2015WrxThread | Shrek