Looking back I'm quoting your post for me to reference later. Check continuity between all 3 wire combinations to each other?
Originally Posted by Underdog
Let me know if it oscillates regularly, or if it is erratic. Better yet, feel free to send me a log. These are new GSC stage 1 cams? How deep into the wiring harness did you go for the swap? I would check the continuity between E1/E2 and the cam sensor, specifically the signal return wire, before even trying to swap sensors.
RH Cam Position Sensor
Sensor Connector (E36) #1 -> Large Connector (E2) #48
Sensor Connector (E36) #2 -> Tan Connector (E1) #1
Sensor Connector (E36) #3 -> Large Connector (E2) #19