View Single Post
#2: 09-06-2013, 02:50 PM
 
 valkrie hunter
valkrie hunter's Avatar
Title: Senior Member
Location: Cerritos/Pomona, CA
Car: '10 SWP LGT
Posts: 293
iTrader: (1)
Send a private message to valkrie hunter Find all posts by valkrie hunter Reply With Quote
So after fabbing up the lip, I felt I needed to strengthen the brackets between some of the pieces (where the silver is seen on the pictures above). I used acrylic sheets to hold everything in place. Then filled each of the pieces with plastic epoxy from JB Weld and sand everything smooth. I need to finish fabbing up the brackets from when I initially cut the lip to fit the contour of the bumper




Last edited by valkrie hunter; 04-15-2014 at 11:38 PM..