View Single Post
#1: 02-28-2013, 07:04 AM
Cannot log WOT pulls
 
 Cone_Killer
Cone_Killer's Avatar
Title: Contributor
Location: Charleston, SC
Car: Blue one and a red one
Posts: 649
iTrader: (11)
Send a private message to Cone_Killer Find all posts by Cone_Killer Reply With Quote
I have done tons of research on this problem with no fix yet. My issue is this; I can flash, use learning view and log normal driving without any issues. As soon as I try a WOT pull, it cuts out anywhere from 3-4.5k. When it cuts out, romraider says "connecting". So far this is what I have done to try and fix:

Load test battery (597 out of 600cca and 12.97v) its good
Check and clean engine grounds (two head to frame and the top of tranny)
Installed 3 ferrite magnets on the OBD harness before plug
Installed 1 ferrite on the vagcom cable after the OBD plug
Disconnected my phone charger
Turned the radio and A/C off

I have tried logging with vagcom and a Tactrix 2.0. I have also tried stand alone SD card logging with the Tactrix and it doesn't turn off but the data is sporatic and repeating. I have included a log from each style and posted them labeled accrodingly.

Any help would be greatly appreciated because I have to start this tune with Cryo.
Attached Files
File Type: csv Vagcom log.csv (3.4 KB, 17 views)
File Type: csv 2nd gear pull Tactrix USB cable.csv (2.7 KB, 19 views)
File Type: csv 2nd gear pull Tactrix SDcard.csv (4.3 KB, 14 views)
File Type: csv 3rd gear pull Tactrix SDcard.csv (6.7 KB, 17 views)
Sponsored links