View Single Post
#796: 02-07-2013, 03:42 PM
bucko3the7man's Avatar
Title: Yeah!! Traction bitch!
Rank: Donating Member
Location: Methuen, MA
Car: 05 Legacy GT BrenTuned
Posts: 4,005
iTrader: (16)
Send a private message to bucko3the7man Find all posts by bucko3the7man
Originally Posted by CT08Spec.B View Post
Was it hard to do? Link?
Very easy.

Remove end cap, pedal undertray (3 pop its), driver dash cover (one screw, rest just popped out), lower steering wheel cover (one screw, rest just popped out), brace for underneath driver dash cover (two 10mm bolts). OP didn't remove the brace but I did so it was easier to move things around.

Supplies used:

-phillips screw driver
-10mm socket/wrench
-about one foot total of wire I had laying around from when I wired some other stuff, one length of 10" and one of about 2"
-one butt connector
-three tap splices
-vice grips (for butt connector crushing and tap splices crushing)
The Following User Says Thank You to bucko3the7man For This Useful Post:
BigBlack-V (02-07-2013)