View Single Post
#26: 01-04-2013, 12:09 PM
 
 KCwagon
KCwagon's Avatar
Title: Wagon Mafia Wiseguy
Location: Kansas City area
Car: 05 GT GRP 6-speed wagon, BNR18G
Posts: 1,531
iTrader: (69)
Send a private message to KCwagon Find all posts by KCwagon Reply With Quote
Quote:
Originally Posted by SBT View Post
Good idea and appreciate the initiative. Given the scope, have set you up as a homebrew vendor for the time being.

I'll likely be installing my BNIB Black WBR FMIC which has a huge cross-section, so will this require custom fitting? 30" core and 3" end tanks by 9" high.

GL with the project.
I can fabricate the pieces any dimension you need/want. The 4"x6" pieces can be cut from a 4'x8' sheet of Anodized Aluminum without any waste, which saves everyone $. Most of the larger intercoolers such as the AVO and Perrin and (sounds like the WBR) require 30" pieces to cover the entire core. My next challenge is to figure out a safe/economical packaging and shipping method for 30" strips of metal