View Single Post
#449: 12-16-2012, 04:13 PM
 
 tophat1995
Title: New Member
Location: Connecticut
Car: 2010 Legacy 2.5i CVT 4 cylinder
Posts: 14
iTrader: (0)
Send a private message to tophat1995 Find all posts by tophat1995 Reply With Quote
Quote:
Originally Posted by lilgrinch View Post
I installed the 19mm sway bar last night. I had trouble with the nuts on the end links and ended up taking the end links off attached to the old bar. It wasn't hard to do at all. Ended up using a pair of vice grips on the stud to keep it from spinning while i was taking the nut off
I gave up trying to get these two nuts off - too cumbersome once the nuts start loosening it's get harder and harder to keep loosening because the rusted bolt jams it up. Do you really recommend taking off the tie rods? I guess I'll give it a shot!