View Single Post
#133: 10-23-2012, 07:51 AM
 
 drewk2
drewk2's Avatar
Title: Junior Member
Car: 2005 Subaru Legacy GT Limited Automatic
Posts: 30
iTrader: (0)
Send a private message to drewk2 Find all posts by drewk2 Reply With Quote
Quote:
Originally Posted by brich1414 View Post
Hey I am in the middle of a timing belt replacement and after removing the old timing belt my cam pulleys on the driver side have shifted and are out of line now. I have since read that it is good to put vice grips on these to keep them in place before removing but I am past that now and was wondering if anyone knew the best way to get these pulleys back in line and keep them there? Any help or suggestions is appreciated.
Luckily, I have VERY strong hands and wrists and turned them back to the center and held them while my friend installed the vise grips.