View Single Post
#2635: 10-11-2012, 10:53 AM
jasejase's Avatar
Title: <><><><><><><>
Rank: Donating Member
Location: Connecticut
Car: S6 and Silverado. Sold Stage 3 specb.
Posts: 32,396
iTrader: (21)
Send a private message to jasejase Find all posts by jasejase
Originally Posted by fysics View Post
I need to check the rears and will check the fronts again tonight once I put on a few miles.

if you don't count the 2x that I took it out and tried to refit I'd say about an hour and 15min. I find this post to be about the most true

definitely had to flatten the bracket, only installed 2/5 bolts (going to go back with more light to see if I can fit one of the smaller ones), and my fitment of the cup isn't quite square on the master cylinder itself.

will hopefully have some comments on impressions tonight, short drive into the office for me.
so the only two bolts that you installed were the ones for the fuel line holders (near the bracket you flattened)?? No bolts on the inner portion of the bracket in to the strut tower?

If that's the case, thats not correct.