View Single Post
#2462: 10-06-2012, 08:52 PM
BarManBean's Avatar
Title: Hicksta V2.0
Rank: Moderator
Location: Northern VA
Car: '05 OBXT 6MT (gone). '15 F150 3.5TT
Posts: 15,961
iTrader: (149)
Send a private message to BarManBean Find all posts by BarManBean
FINALLY, I have installed both a rear sway bar and a front sway bar. I've had whitelines for a good six months now, never got around to installing the fronts.

Both hotchkis bars are in now. Changing the rear out wasn't to bad since all the hardware was new, including KB endlinks. Changing the front was a different story--getting stock endlinks of SUCKS. I went through three blades on the sawzall and swore quite a bit, but I got those fukcers off. Then I had a beer. Then I buttoned everything up.

Now I'm gonna have another beer, because I deserve it dammit.
"Bullet-proof" your OEM TMIC! <<Buy your kit here>>

Not currently in stock
The Following 4 Users Say Thank You to BarManBean For This Useful Post:
BigBlack-V (10-07-2012), DeltaNu1142 (10-07-2012), fysics (10-08-2012), Turkeylord (10-06-2012)