Just to let everyone know... The Clean Sweep uses some pretty cheap Molex style connectors that tend to fail, both on the circuit board and on the output cables. I've had one installed for about four months and have had several problems with the system just quitting on me. I'll go in and reseat the wires inside the Molex to get the system up and running again.
The installer was saying that he has had a few units where he had to solder connections to the circuit board to ensure a decent connection.
I'm also having grief with the remote out to amp turn on not turning on the amp. We put in a relay that seemed to work for a while, but currently I'm running silent.
Other than that, when it's working the sound is phenominal. I've got it running into an old Alpine V12 MRV F-400 Amp going to Quarts front and rear. I picked up some mounts from ProClip USA and took out their dock cable and replaced it with a Belkin F8V7058-APL that allows for charging and audio input to the Clean Sweep with very good sound. When it's working.
If I come up with any permanent fixes, I'll post.