View Single Post
#9: 09-07-2012, 06:30 PM
 
 silentguy
Title: Member
Location: Pacific NW
Car: 1998 Subaru Legacy GT
Posts: 105
iTrader: (0)
Send a private message to silentguy Find all posts by silentguy Reply With Quote


The Cam Cap bolt on the bottom right of the photo, is the one that was stuck and needed to be
chiseled out. Its the one closes to the indentation, lower right of this photo, Far left when looking at the head as installed.

The bolts are not in the pic, you just look at the bolt holes to know which one I am talking about.

I used a dremel and a diamond coated cut off wheel, to cut a slot in the bolt head ( which was too rounded to remove),
then a cold chisel to punch it counter clockwise, and it came out easily.

I had tried all kinds of bolt removers, which did not work, also vice grips wouldnt budge the bolt.



This is cylinder head on the camshaft side.

Last edited by silentguy; 09-07-2012 at 07:07 PM..