View Single Post
#11: 07-27-2012, 02:10 PM
 
 paintpollz
paintpollz's Avatar
Title: You take drugs, Danny?
Location: Every day........... Good. Then what's your problem?
Car: I don't know.
Posts: 2,524
iTrader: (10)
Send a private message to paintpollz Find all posts by paintpollz Reply With Quote
Quote:
Originally Posted by BarManBean View Post
Are you positive that you put the adaptor, donut, and 3" gasket in the right order at the DP-to-CBE connection?

You should have a normal 2-bolt (3") gasket up next to the DP, then the adaptor with the protrusion facing towards the rear of the car, and the donut gasket with the tapered end towards the rear of the car. Just trying to make sure here.

If that's the case, tighten the shit out of that connection just to rule it out for sure before you do everything else. Tighten each bolt a little bit at a time.
I don't think you can mess that up, but, I did install it in the correct way that you are mentioning. I torqued it pretty hard, hard enough where the stock cbe flang is bending all the way into the adapter