View Single Post
#19: 06-08-2012, 01:09 PM
 
 Hoojammyflip
Hoojammyflip's Avatar
Title: Member
Location: Lancashire, UK
Car: 2.0GT spec.B JDM (STi8 sh eng) '89 ZX10
Posts: 161
iTrader: (0)
Send a private message to Hoojammyflip Find all posts by Hoojammyflip Reply With Quote
Quote:
Originally Posted by winnipegsubaru View Post
Yes it is the one to match the clock connector
I can't find that connector available to the UK $4 and $5000 P&P LOL - Might have to do a bodge on the connector Is it possible to get the pins with out a block and poke them in to the required positions and then set the whole thing in a block of resin or something? Effectively create a block connector? - just a thought...

I amalgamated all your wiring connections into a chart to make it a bit simpler for my befudled brain If you could check I have understood your plans and it might help someone else too...



In case it helps anyone else - this is my clock connector...





As well as the cubby light power connector ( V and BY I think ) there is also this one...



P, BW and 2x V - don't know where that comes from / goes to...