View Single Post
#2: 04-23-2012, 03:30 PM
 
 winnipegsubaru
winnipegsubaru's Avatar
Title: Senior Member
Location: Winnipeg, MB
Car: 2006 Legacy 2.5i
Posts: 247
iTrader: (9)
Send a private message to winnipegsubaru Find all posts by winnipegsubaru Reply With Quote
Edit
-----------------------------------------------------------------------
Ok, So I made my full harness.

Click image for larger version

Name:	Full.jpg
Views:	71
Size:	498.5 KB
ID:	118353

The following picture is of my home made breakout harness (takes all but 4 wires from the clock connector, Which I did not cut)
Click image for larger version

Name:	BreakOut.jpg
Views:	83
Size:	508.3 KB
ID:	118354

Then it goes down to the dvd player, the white wire hanging out is a chassis ground (will ground to seat post probably)
Click image for larger version

Name:	DVD Connector.jpg
Views:	61
Size:	511.4 KB
ID:	118355

These are 3 of the wires that I mentioned above, these go to the i10 connector behind the gauges.
Click image for larger version

Name:	Behind Guages.jpg
Views:	54
Size:	509.3 KB
ID:	118356

The 4th wire that doesnt go to the clock connector is the reverse signal. Since I dont currently have a backup camera, I opted to not connect this.

I then did a quick test in the car (didnt worry about the 3 wires to behind the gauges for this test) and WOOHOO it works. Ran the car for about 20 min, just to verify that the wire wasnt to thin.

Click image for larger version

Name:	IMG-20120517-00050.jpg
Views:	79
Size:	498.1 KB
ID:	118358
Click image for larger version

Name:	IMG-20120517-00053.jpg
Views:	68
Size:	499.9 KB
ID:	118359
-----------------------------------------------------------------------
OK, so I have made my adapter to go from the clock harness to the 16pin nav screen. See below.

Just a side note, I still need to tap a few of these wires to run to the DVD player that will be under the drivers seat.

Click image for larger version

Name:	IMG-20120516-00047.jpg
Views:	71
Size:	499.9 KB
ID:	118264

I am trying to take my time at this, to cut as few wires as possible, and to do the install correctly.

If anyone has any input that would be great.

Also, there are still 4 wires that are not accounted for

2 canbus wires, 1 VDC, and 1 Reverse

Thanks

***Note: Big Thanks to BigTDogg to finding the connectors to extend / adapt the clock harness connector.***
** If you would like to buy these connectors and pins please look here: *http://easternbeaver.com/Main/Elec__...onnectors.html

Edit - November 19th 2012 - Adding connector Part Numbers

Vendor Part Number Description Location
Tyco 174147-2 16-pin Harness Back of Screen
Tyco 174047-2 20-pin Harness Back of Screen

Last edited by winnipegsubaru; 11-19-2012 at 04:13 PM..