Hey everyone, below is a write up I did for myself as I am trying to install the OEM nav into an 06 2.5i legacy.
If you could read the below, and comment on any info you might have (ie if I have the pins correct, or possibly where the connector is located in the car) That would be great.
I was originaly going to pull the wires off the OP connector, but since my 2006 Subaru does not seem to have an OP connector, I decided to pull as much as I can off the clock connector.
I have yet to install this, I have just been doing my homework thus far
Looking at the back side (where the wires are) [Nav System Screen]
10 Pin i50 Connector (looking from the back side) [Nav System DVD Player]
Pin 1 = NC
Pin 2 = To Pin 7 on Screen
Pin 3 = NC
Pin 4 = NC
Pin 5 = To Pin 4 on Screen
Pin 6 = Ground
Pin 7 = To Pin 8 on Screen
Pin 8 = To Pin 11 on Screen
Pin 9 = NC
Pin 10= To Pin 12 on Screen
Once I get this all sorted out, I will work on the audio portion of it.
Hope this helps someone else down the road