View Single Post
#2: 03-03-2012, 05:58 AM
 
 compsurge
compsurge's Avatar
Title: Burning Monkey
Location: Delaware
Car: '05 5MT ABP LGT wagon
Posts: 2,601
iTrader: (11)
Send a private message to compsurge Find all posts by compsurge Reply With Quote
I guess IPR TMIC is a knockoff of Perrin, which doesn't state much.

I've been fairly satisfied with mine after I figured the washer shim out for clutch master cylinder clearance. Fitment was pretty good. I did end up buying an AVO TB inlet hose to make it easier to install. No trimming of the hose was required.

I got the Swaintech heat coating, but I doubt it really does anything. The paint is evenly coated.

Welds look good, fins were good, I don't recollect any burrs or other manufacturing finishing issues.

I would call it a "buy".

Last edited by compsurge; 03-03-2012 at 06:00 AM..